|
Pictures of the layouts in JPEG
Click on an image to see an enlarged (better) image of the layout.
Notice, the copper sides are vertically rotated, so left is still left, and right is still right...
also, ignore the bolts on some of the Layout component sides... these can be anywhere you like...
|
|
|
Dual LFO Component Side
The wirebridges that link P1R to Square Out are better off being a glob of solder on the copper side, wire bridges here are just to point out connection. |
|
|
Dual LFO Copper Side
|
|
|
Dual VCA Component Side
Make sure that the wirebridge between IC1(tl082) pin 1 and IC2(CA3080) pin 7 doesn't short with the nearby resistor, insulate it! |
|
|
Dual VCA Copper Side
|
|
|
VCO Component Side
This image is severely squished, to help make the layout more clear... Click the image to see it in true width..
Notes: Please DO thermally connect the two 2n3904's... and insulate wirebridges where they cross over resistors and the lot. Check the alignment of the FET. |
|
|
VCO Copper Side
This image is severely squished, to help make the layout more clear. Click the image to see it in true width..
Notes: There are some very long wirebridges on this side of the board, which might bend to connect with a strip on the board, so for safety, use insulated wire on the back, even for resistors...
|
|
|
|
